1
of
3
Loading...
Description
Description
Tenax EZ Sticky Stuff StrongEdge Dispenser With Heater — Adhesive Application System
The Tenax EZ Sticky Stuff StrongEdge Dispenser is a heated applicator for the Tenax Sticky Stuff family of stone-edge adhesives. The integrated heater warms the cartridge so the adhesive flows at its correct viscosity, giving the fabricator a clean, uniform bead on edge laminations and seam work. Engineered for production-shop use where consistent adhesive delivery directly affects edge-build quality.
Features
- Heated cartridge dispenser for Tenax Sticky Stuff adhesives
- Integrated heater warms the cartridge to correct application viscosity
- Designed for stone edge lamination and seam work
- Production-shop applicator
- Italian Tenax cartridge ecosystem
- Mains-powered (verify voltage on the unit before connection)
| Property | Detail |
|---|---|
| Brand | Tenax |
| Part Number | SS-ADJ |
| Product | EZ Sticky Stuff StrongEdge Dispenser with Heater |
| Power | Mains-powered — verify voltage on unit |
| Compatibility | Tenax Sticky Stuff adhesive cartridges |
- Verify the dispenser's voltage rating matches the shop power supply.
- Plug into a properly grounded outlet.
- Load the Sticky Stuff cartridge per the unit's instructions.
- Allow the heater to bring the cartridge up to operating temperature before dispensing.
- Apply controlled beads to the edge or seam.
- Power down and let cool before storing.
- Wear ANSI Z87 eye protection, hearing protection, and a dust-rated respirator.
- Use cut-resistant gloves where applicable.
- Verify the tool is rated for the stone material before starting.
- Inspect the tool before each shift; remove from service if cracks or excessive wear are visible.
- Heated unit — do not touch the heating block during or immediately after use.
Always wear ANSI Z87 eye protection, hearing protection, and a dust-rated respirator when running stone abrasives. Verify wet water feed before each cut where applicable.
