Bellinzoni Eureka Quartz Resin Polishing Gel 1 L

Bellinzoni Eureka Quartz Resin Polishing Gel 1 L

Bellinzoni Eureka Quartz Resin Polishing Gel 1 L is a professional Bellinzoni polishing product engineered for stone surface finishing. Bellinzoni — chemistry for stone since 1937, ISO 9001:2015.

Features

• EUREKA QUARTZ RESIN EUREKA is a new polishing gel, special for polish quartz resin quickly and easily, just using a single disc machine. EUREKA QUARTZ specifically is the ideal product for polishing engineered stones quartz based (I.E.: SILESTONE, OKITE, SM Quartz, LIVING, GULFSTONE QUARTZ etc ... (*). Material can be treated to restore or to increase the original gloss, to enhance the color and to correct imperfections caused by natural wear and tear of materials.(* ) material names and trademarks are the property of their respective owners, the citation is for examples purposes only)
• Method of Use: APPLICATION ON TABLES, BATHROOM OR KITCHEN WORKTOP, BAR COUNTERS AND CLADDING Surface preparation: the surface must be dry and clean. Wash the surface to remove dirt and any residues of old waxes and treatments (we recommend using our ULTRA STRIPPER); rinse thoroughly and dry. Apply a small amount of product (10–15 g) to the surface to be treated, moisten with a few drops of water; place the Eureka Pad on the gel and polish using an orbital sander with adjustable speed set to a low rpm, between 800 and 1500 rpm (1000 rpm is optimal). Work the surface until the gel has completely dried and the desired shine has been achieved. Clean any residue with water and a neutral detergent. If necessary, the procedure described above may be repeated. FLOOR APPLICATION: Surface preparation: the surface must be dry and clean. Wash the floor thoroughly using a single-disc machine and a suitable pad, removing dirt and any residues of old waxes and treatments (we recommend using our ULTRA STRIPPER); rinse very thoroughly and dry with a wet vacuum. Apply a small amount (approximately 30 grams) of Eureka directly onto the floor, under the natural bristle pad, moisten slightly, then buff with a single-disc machine (at 150–400 rpm and a minimum weight of 30 kg) over approximately 1–2 m² of floor. Spray or pour water if the gel dries too quickly during application. After applying the product, work the surface until the gel dries, achieving the desired shine. Finally, wash and rinse with water and an alkaline substance (soda, bicarbonate of soda or our LEM-3 or ULTRA STRIPPER detergent) to remove any product residue and neutralise any residual acidity.
• Coverage: Con un litro di prodotto si possono trattare circa 30/40 m2. Technical Data Sheet

Industrial chemical product. Use only in well-ventilated areas. Wear chemical-resistant gloves and eye protection. Read the Bellinzoni Safety Data Sheet (available from the manufacturer) before use.